accesssories | Buffers

		Code	Specifications
'D' section (hollow) Normally placed around the edges of the trolley (between corner buffers) to prevent damage to door jambs, etc. Fitted by pushing a (off-cut) metal strip along the centre of the section and screwing through into the side of the trolley. The head of the screw will pop through the outer rubber leaving a small hole. If the strip is to be fitted on a rounded corner, this should be of at least 50mm radius to prevent buckling of the strip.			Colour	Metres/Ft per spool	Metres/Ft per bag	Cut lengths
		D25SPOOL D25BAG D25CUT	Pewter grey	80 262.4ft	8 26.24ft	as required up to 80 metrers 262.4ft
		D25SPOOL D25BAG D25CUT	A premium is paid for 'bag lots' or 'cut lengths'
Buffers - leg Round TPE (Thermo-Plastic Elastomer) These are used to prevent damage to corridor walls. The buffers are placed onto tubular legs just before the castors. When a trolley approaches a wall the buffers make contact first and freely revolves on the tubing, thus rolling the trolley along the wall so it causes no damage. In the case of 25.4mm (1") square tubing the urethane buffers are supplied with a 38mm (1 1/2") hole, together with a 'dress-cap' with a 25.4mm (1") square inner and a 38mm (1 1/2") round outer.	pewter gray	Code 100mm	Code 125mm	Colour	To suit tubing OD
		BJ100X25	BJ125X25	Pewter grey	25.4 mm 1" round
		BJ100X32	BJ125X32		32mm 1¹/₄" round
		BJ100X25SQ	BJ125X25SQ		25.4 mm 1" square
		Dress cap - BJDC25		Black	25.4 mm 1" square
Buffers - corner TPE (Thermo-Plastic Elastomer) Corner buffers can be fitted to new or existing trolleys with square corners. They stop much of the damage to walls, door jambs, etc. They are fitted by four pan head self tappers, which are recessed down inside each arm of the buffer (No. 10x1" or similar). Being made from TPE they are very resistant to abrasion, chemicals, etc. The end profile is matched to the 'D' section rubber strip.					Code	Colour
					CB8025	Pewter grey

Copyright © 2010 Fallshaw Pty Ltd. All Rights Reserved.